| 沥青高粘剂的使用注意要点 |
| 添加时间：2017/7/26 20:24:34 浏览次数： |
| 1、被粘物一定要清洗干净，不能有水份（除水下固化胶）。 1. The adhesive must be cleaned and not water (except for the water curing adhesive). 2、为达到粘接强度高，被粘物尽量打磨， 2. To achieve the high bonding strength and the adhesive to be polished, 3、粘接接头设计的好坏，决定粘接强度高低。 3. The design of adhesive joints is good or bad, and the strength of bonding strength is determined. 4、沥青高粘剂使用时，一定要现配现用，切不可留置时间太长，如属快速固化，一般不宜超过2分钟。 4. When used with asphalt binder, it must be present and used, and the time of unencumbrance should be too long. If it is fast curing, it should not exceed 2 minutes. 5、如要强度高、固化快，可视其情况加热，涂胶时，不宜太厚，一般以0.5mm为好，越厚粘接效果越差。 5. If the strength is high and the solidification is fast, the situation should be heated. When applying the glue, it should not be too thick. Generally, it is better to have 0.5mm, and the thicker it is, the worse it is. 6、沥青高粘剂粘接物体时，最好施压或用夹具固定。 6. When the asphalt viscous material is bonded to the object, it is preferable to press or clamp. |
| 上一页 沥青高粘剂的优势 |
| 下一页 没有了 |
Copyright © 技术支持：遨游网络